Blake Stamper's latest activity
-
Blake Stamper replied to the thread DIY tub sliders?.Copy that, straight it is! -
Blake Stamper replied to the thread DIY tub sliders?.Makes sense, thanks for the info!!
-
If the aluminum bar could be bent to fit the curve cleanly, we would see more DIY versions like this. The aluminum cracks. That is a...
-
No need if all we are building is the straight section above the wheel opening. If the goal is to get a nice bend around the corner, a...
-
Blake Stamper replied to the thread DIY tub sliders?.That’s where I’m at, the bend looks good but idk if I could pull it off
-
I have the savvy rails. If I didn’t have them then I would probably just make a straight aluminum piece and not worry about the curve...
-
Blake Stamper replied to the thread DIY tub sliders?.Thanks this was the one I was looking for!!
-
No, WA has wheel coverage laws. They’re ready to go when I wheel on the West side of the state where trails get narrow. I’m looking...
-
Here’s a link to my fab process. They are non-radiused. Post in thread '05 Flame Red TJ Build'...
-
Blake Stamper replied to the thread DIY tub sliders?.Awesome! I thought I remembered you doing them but clearly didn’t go far enough back in your build thread. You get a chance to use them yet?
-
Blake Stamper replied to the thread DIY tub sliders?.I’m loving what flux is up to but I was referring to the tub rail, as in the stainless steel bar that went into the top of corner armor...
-
-
Ask and you shall receive. Post in thread '2004 LJ In Flux' https://wranglertjforum.com/threads/2004-lj-in-flux.57641/post-1532268
-
With savvy tub sliders appearing to be gone at this point, I was wondering who all here has made their own tub sliders, I know starkey...
-
With all parts and hardware included. Bumper, winch tray and rash guards it came out to 21lbs. Now that is measured on a shipping...
-
No, I forgot this was on my list. I will shoot for tomorrow. Some of you where asking about LJ corner Blanks. I remember the...
