Brianj5600
TJ Expert 56 From Middle Tennessee
Latest activity Postings Attachments Images About
-
-
Brianj5600 replied to the thread Noisy carrier bearings?.I did both rear axles with Timken 9912s seals and the rest Spicer. The old axle bearings sounded like there was gravel in the bearings... -
Brianj5600 reacted to Tob's post in the thread Removing rear driveshaft to test for vibes with
Like.
Yes it is really okay. According to WTJF code, section 4, article 15 (b), exception (2), temporary removal of the rear driveshaft for... -
Brianj5600 replied to the thread Noisy carrier bearings?.I'm going to dig into it this weekend and will report back. @hear here's a clip from BFH Garage showing the actuator on a factory locker.
-
So I cant provide much assistance with the whine. However this is literally sitting at my front door waiting for me to get home. I...
-
It was dry and dusty when I went. If you look at the still pic in the vid above, I used my driver side rocker guard to pivot off that...
-
Brianj5600 replied to the thread Noisy carrier bearings?.It kinda sounds like straight cut gears starting at about 30 mph. The pitch goes up until wind and tire noise drowns it out at 45 or 50 mph.
-
Brian, You will be fine on Walden's ridge. That first obstacle, you can go way right and avoid it if needed. If you go further right...
-
Brianj5600 replied to the thread Noisy carrier bearings?.I doubt it is really an issue changing that bearing. Just one more thing to go wrong. What clamshell do you have?
-
-
Brianj5600 replied to the thread Tennessee Windrock Timing?.Thank for the heads up about damage. I have some real rockers to put on in the next few days. What were the conditions when you were...
-
Brianj5600 replied to the thread Tennessee Windrock Timing?.I got an invite to do Walden's Ridge. I'm kind of curious about what you meant by well built rigs.
-
Brianj5600 replied to the thread Noisy carrier bearings?.Thanks for the reply. I have a stock Rubicon locker. The locker mechanism is held on to the carrier by the bearing. Next step is to...
-
For those that knew Joe (Big Wall on the forums), he had been battling cancer for a couple of years. Unfortunately, Joe passed away...
-
I regeared 4 or 5 years ago and the rear has been making gradually more noise. I replaced the pinion bearings and no change. I didn't...
-
Brianj5600 replied to the thread What lift am I running?.Measure the spring length with the Jeep on the ground and report back.
-
Brianj5600 replied to the thread 1" motor mount lift hardware.https://www.mcmaster.com/products/threaded-standoffs/ You might have to turn them down. It should be easy to turn down the hex with a...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
