- Price
- 0
- Location
- Northern WI
This CV style driveshaft has less than 2k miles on it (probably closer to 500 since I had the hubs unlocked so this wasn't spinning).
It was just shortened and balanced by Tom Woods and has 0 miles on it since. Only a day of cycling my axle in the garage.
It has 1310 joints and it's made for 36.625" yoke to yoke.
Be aware that this shaft is a smaller 1.25" in diameter so it's not suited for a rear shaft and smaller than stock for the front. Good if you have clearance issues or for a spare. Not good for cruising down the highway (either use locking hubs or tie up the driveshaft on the highway).
It was just shortened and balanced by Tom Woods and has 0 miles on it since. Only a day of cycling my axle in the garage.
It has 1310 joints and it's made for 36.625" yoke to yoke.
Be aware that this shaft is a smaller 1.25" in diameter so it's not suited for a rear shaft and smaller than stock for the front. Good if you have clearance issues or for a spare. Not good for cruising down the highway (either use locking hubs or tie up the driveshaft on the highway).