Sean B
Member 46 From Winsted Connecticut
Latest activity Postings Images About
-
-
Sean B replied to the thread Trouble with severe vibration 25-50 mph.It would be odd but you never know. Always easier to figure something out if a problem happens after you do something. I found a pic... -
-
Sean B replied to the thread Trouble with severe vibration 25-50 mph.I explained this wrong, they need to be aligned, so the forces cancel each other out. I had to look at one to visualize it. I attached...
-
-
Sean B replied to the thread Trouble with severe vibration 25-50 mph.One thing to check is to make sure the drive shaft is properly phased. If take the slip yoke apart is is possible to put it back...
-
OK I’m trying to understand the situation- Is this at a shop down there or a vacation property or does one of your children live out of...
-
Been around forever. Lots have been "fixed" by welding the mount to the frame but they suck to remove when you figure out how much...
-
Sean B replied to the thread Help me figure out what I have?.I agree, mine was rough country and had the same bracket. I removed the bracket and drop pitman arm and replaced with Rockjock and OE...
-
I bought a bone stock 06 Rubicon with 24k miles in perfect condition, so I'm realllly trying to avoid doing anything but bolt on mods...
-
Sean B replied to the thread Leaking rear axle seal problem.I ended up pulling them quick, 1/2 difference in length. Since I took it apart to check of course I had them right. Only time I would...
-
Sean B replied to the thread Leaking rear axle seal problem.Now I feel dumb. I recently did my seals and bearings. I had both axels on bench and never noticed they were different lengths. Is...
-
Sean B replied to the thread Frame Side Track Bar Mount Shot.That makes sense, I didn’t know the lower lift bar would work with larger lifts. I was not a fan of the 4-6 inch bar, the issue was...
-
Sean B replied to the thread Frame Side Track Bar Mount Shot.I previously had their bar which necessitated their drop/relocation bracket that bolts to the stock bracket and requires some 15/16...
-
I have had good luck with Classic Tube & Inline Tube for these sorts of things, although I have not used them for any of my TJ projects.
-
Sean B replied to the thread Rear sway bar question.Does this seem right, just seems loose to me. Measuring bolt and sleeve there is .057 clearance?
-
Sean B replied to the thread Rear sway bar question.Thanks, without measuring there is probably .060-.070 slop between the sleeve and the shoulder bolt. That does make sense that with the...
-
So I’m having some difficulty sorting this out. I am attempting to install my rockjock extended links in the rear. I had some previous...
-
-
-
Loading…
-
Loading…
-
Loading…
